Balers

Horizontal Baler > Gemini Series Balers
Gemini 3650 and Gemini Xtreme Literature
The Gemini 3560 and Gemini-Xtreme Balers are moderate duty, closed-end horizontal balers that allow you to process a variety of material such as PET, aluminum or steel cans, paper, plastics, OCC, newsprint, and similar material. Because bales are tied vertically, no fluffing or preconditioning is required.

  • Full penetration ram for dense bales and full bale ejection
  • Programmable controller
  • Twin cross-cylinders with 20 HP motor
  • Cycle time of 34 seconds
  • Bale size (OCC) 30"H x 48"L x 60"W
  • Hardened steel tongue & groove floor (Gemini-Xtreme only)
  • Adjustable cold roll bar assembly hold-down system with integrated drag plate for ram (Gemini-Xtreme only)
  • Wire guides for tying through the bale chamber door
  • Optional Variable speed conveyor
  • Hopper with access door with interlock and viewing port
  • Electrical disconnect
  • Reversible and adjustable bolt-on shear blade (Gemini-Xtreme only)
  • Welded body shear blade and serrated ram shear bar (Gemini 3560)
  • Nylon runners for smooth ram operation
  • Dual interlock on bale chamber door
  • Lower photocell control
  • High efficiency power unit with TEFC motor and horsepower limited, pressure compensated piston pump

Optional Features:

  • Above Floor Conveyor (includes variable frequency drive & hopper extension)
  • Pit Conveyor (includes variable frequency drive & hopper extension)
  • Hydraulic Bale Door Release
  • Oil Heater & Oil Cooler

More BALERS from Georgia Baler and Compactor

Baling Wire
Clothing Baler
Horizontal Baler
Vertical Baler